crome pro anyone?
#22
Guest
Posts: n/a
Re: crome pro anyone?
Originally Posted by Joseph Davis
http://www.hmt-tv.com/hmt/joseph/crome1.2.0.24.zip
I dunno if P30 bugs have been worked out yet, been running P72 code. Yes - P72 finally properly supported in Crome.
I dunno if P30 bugs have been worked out yet, been running P72 code. Yes - P72 finally properly supported in Crome.
#24
Re: crome pro anyone?
instead of burning a chip you just upload the bin to your ostrich and your good to go . it is very helpfull when tuning because you don't have to burn a new chip with every change you make to the map, you can make a change and it will be updated into the ostrich. i love mine.
#25
Re: crome pro anyone?
Originally Posted by jeffsciv23
instead of burning a chip you just upload the bin to your ostrich and your good to go . it is very helpfull when tuning because you don't have to burn a new chip with every change you make to the map, you can make a change and it will be updated into the ostrich. i love mine.
#26
Re: crome pro anyone?
Originally Posted by jagojon3
When I run that version in "about" it says 1.1.14?
Welcome to betasoft meant to be tested, that is not an official release and therefore polished.
#27
Re: crome pro anyone?
Originally Posted by Joseph Davis
http://www.hmt-tv.com/hmt/joseph/crome1.2.0.24.zip
I dunno if P30 bugs have been worked out yet, been running P72 code. Yes - P72 finally properly supported in Crome.
I dunno if P30 bugs have been worked out yet, been running P72 code. Yes - P72 finally properly supported in Crome.
#28
Re: crome pro anyone?
With FVFT RC2 (last week's stuff), P72 was supported and P30 was not.
I have tunes one car with 203/P30 code with RC4, everything ran pretty well except for the plugs... 8 psi on a B16, SSAC .50 T3/T04E, Lovefab ram horn... the car had a set of 8's in it, the #1 plug was cold and wanted a 7, where #3 was discolored to the threads and wanted a 9. It's either code bug, which I am doubting because ICT worked, or bad flow across the stock B16 IM.
I have tunes one car with 203/P30 code with RC4, everything ran pretty well except for the plugs... 8 psi on a B16, SSAC .50 T3/T04E, Lovefab ram horn... the car had a set of 8's in it, the #1 plug was cold and wanted a 7, where #3 was discolored to the threads and wanted a 9. It's either code bug, which I am doubting because ICT worked, or bad flow across the stock B16 IM.
Thread
Thread Starter
Forum
Replies
Last Post
Minor Threat
Engine Management
2
09-21-2007 09:46 PM
MyVtec8yourV8
Engine Management
7
01-18-2006 04:10 PM