Re:cheapest way of fuel management
Hey Joseph If I put in the 450cc injectors with the George hack, Will it compensate for the 450cc injectors?
|
Re:cheapest way of fuel management
George's MAP sensor cut is a little bit more than the usual -40% AFC cut. You can just toss 450cc injectors in there and drive as long as you aren't forced induction - the fuel maps are way too lean to just boost on IMO. You have to fiddle it a bit.
When you alter the .bin in Ghettodyne, the pressure headings at the top are no longer correct, as the last 5 columns are your boost zone. You can run a GM 2 bar MAP with it, yeah, but then you're going to have to refigure where everything is in Ghettodyne. It's a jump from a vaccuum-11.8 psi scale to a vacuum-14.5 psi scale, so the difference between a regular AFC hack and an AFC hack with a GM 2 bar isn't very big. The big difference is that the Honda MAP can't see above 9.25-10.65 psi depending on it's era. |
Re:cheapest way of fuel management
K
Thanx again. Just my bad luck..the PM6 ECU I got is the same as the PM7 i got >:( They don't have an external EPROM I have to make a board etc...hmmm oh well. |
Re:cheapest way of fuel management
Try a 2 inch fuel rail with 4 bosch fiel pumps from the old BMWs in place of injectors. Crank the boost to 50 psi and dont blame me if it dosen't work!
|
All times are GMT -5. The time now is 12:01 AM. |
© 2024 MH Sub I, LLC dba Internet Brands