Re: CEL #16
Originally Posted by Cray91
Can noone read?
Changed the wiring back to stock and I was perfect. If I plug the box back in I get the code. I get 6.2ohms on the box, is that the normal? It seems low to me. |
Re: CEL #16
Originally Posted by xenocron
Thats low...should be about 9-10 ohms
|
Re: CEL #16
Originally Posted by xenocron
Thats low...should be about 9-10 ohms
Originally Posted by Cray91
Same inejctors as before. If there was something wrong with the injectors it would still be there, I didn't change them out.
The reason I asked about the injectors is are you trying to use saturated injectors with a box too? ECU might get low current feedback with that setup and throw the CEL. |
Re: CEL #16
were you the one that had the post of the easy resistor box install?
|
Re: CEL #16
Total ohms in the system should be about 12-13...
The injectors will be 2-3 and the resistors should be 9-10. Why if a resistor box is 6 ohms, does EVERYONE go to Radioshack and get 10 OHM resistors?????
Originally Posted by MADMAX
I have a Honda OBD1 box and it reads 6.3 for each. Others I have checked are around the same readings.
So are they saturated or low impedance? The reason I asked about the injectors is are you trying to use saturated injectors with a box too? ECU might get low current feedback with that setup and throw the CEL. |
Re: CEL #16
Originally Posted by whiterice
were you the one that had the post of the easy resistor box install?
|
Re: CEL #16
Originally Posted by Cray91
Yeah, but there was nothing wrong with the wiring. The box just went to hell.
http://img81.imageshack.us/img81/929...fold093qf8.jpg http://img81.imageshack.us/img81/816...fold092am4.jpg |
Re: CEL #16
Originally Posted by xenocron
Total ohms in the system should be about 12-13...
The injectors will be 2-3 and the resistors should be 9-10. Why if a resistor box is 6 ohms, does EVERYONE go to Radioshack and get 10 OHM resistors????? Using 10 ohm resistors will not provide enough current to P/H injectors. This means that they may not open all the way. Honda uses 6.xx ohm resistor boxes for a reason. This provides the correct current to the injectors. Go check some OBD0 and 1 boxes. They will be around 6 some ohms. Also whiterice's setup is the easiest way to add a resistor box. you only have to cut one wire and that is not even on the harness. You only have to move pins around. |
Re: CEL #16
Originally Posted by whiterice
Post that how-to again. Seemed not as easy as the other way.
http://www.---------------------------/Cray/Rez.jpg http://www.---------------------------/Cray/Rez1.jpg
Originally Posted by MADMAX
Also whiterice's setup is the easiest way to add a resistor box. you only have to cut one wire and that is not even on the harness. You only have to move pins around.
I didn't cut any wires, and I didn't have the resistor box plug. I did have a dizzy plug though. |
Re: CEL #16
I know you're tryin to be all hot with your shrink wrap, but deep inside you know you're having dreams of electrical tape :6
|
All times are GMT -5. The time now is 01:52 PM. |
© 2024 MH Sub I, LLC dba Internet Brands