basemap for my b16a setup needed.. help a nog out
#1
basemap for my b16a setup needed.. help a nog out
to make a long story short, my friend lost my wideband and wont replace it, so i'm stuck running a basemap until I can get another.. so I was wondering if someone could give me a decent basemap for running this setup:
engine specs:
B16A bored .5mm over
9:1 forged pistons and rods
head studs
valve work
gsr cams
springs & retainers
forced induction specs:
garrett t3/t04e 57 trim .60/.63
mitsu evo intercooler
35mm wastegate
steel braided lines
2.5" downpipe
2.5" charge pipes
nissan bov
tuning:
dsm 450cc
p75 chipped ecu
moates datalogger
I found a similar B18a setup on xenocrons bin section, but there's no vtec.. I thought about running the car without the vtec solenoid plugged in.. what do you guys think?? any help would be greatly appreciated.
engine specs:
B16A bored .5mm over
9:1 forged pistons and rods
head studs
valve work
gsr cams
springs & retainers
forced induction specs:
garrett t3/t04e 57 trim .60/.63
mitsu evo intercooler
35mm wastegate
steel braided lines
2.5" downpipe
2.5" charge pipes
nissan bov
tuning:
dsm 450cc
p75 chipped ecu
moates datalogger
I found a similar B18a setup on xenocrons bin section, but there's no vtec.. I thought about running the car without the vtec solenoid plugged in.. what do you guys think?? any help would be greatly appreciated.
#2
Re: basemap for my b16a setup needed.. help a nog out
are you missing a gauge or the O2 sensor?
I have an extra DynoJet / Autometer anolog type gauge laying around if you need one.
I can also get you a 17014 bosch o2 sensor that I use.
I have an extra DynoJet / Autometer anolog type gauge laying around if you need one.
I can also get you a 17014 bosch o2 sensor that I use.
Thread
Thread Starter
Forum
Replies
Last Post
BigD
Turbo Parts For Sale
1
09-21-2008 03:30 PM
juli0_bustamante
Engine Management
4
06-27-2005 04:48 PM