basemap for my b16a setup needed.. help a nog out
to make a long story short, my friend lost my wideband and wont replace it, so i'm stuck running a basemap until I can get another.. so I was wondering if someone could give me a decent basemap for running this setup:
engine specs: B16A bored .5mm over 9:1 forged pistons and rods head studs valve work gsr cams springs & retainers forced induction specs: garrett t3/t04e 57 trim .60/.63 mitsu evo intercooler 35mm wastegate steel braided lines 2.5" downpipe 2.5" charge pipes nissan bov tuning: dsm 450cc p75 chipped ecu moates datalogger I found a similar B18a setup on xenocrons bin section, but there's no vtec.. I thought about running the car without the vtec solenoid plugged in.. what do you guys think?? any help would be greatly appreciated. |
Re: basemap for my b16a setup needed.. help a nog out
are you missing a gauge or the O2 sensor?
I have an extra DynoJet / Autometer anolog type gauge laying around if you need one. I can also get you a 17014 bosch o2 sensor that I use. |
Re: basemap for my b16a setup needed.. help a nog out
xenocron will do it for you for 25
|
All times are GMT -5. The time now is 06:39 AM. |
© 2024 MH Sub I, LLC dba Internet Brands