traff1c

Looking for a Z6 short block.... dont care if the pistons or rods are shot, as long as the block is in good working order...

evosol

ive got a complete z6 shortblock, pistons & rods are still intact.
make me an offer

traff1c

you give me a price.... i hate this whole me having to lowball your ***.... cause you know im gonna say 50$

OnYx

$60 + ship and you can have hte one i have, no crank pully or water pump but the reast is there (pistons, crank, rods and pan)

traff1c

---- how much is shipping to Stanton CA 90680

OnYx

UPS Ground*
Guaranteed Day-Definite***
Total Rate(USD) 30.20*

that is the estimate i was given on a 65 LB load.

UPS Next Day Air Early A.M.®*
Guaranteed by 8:00 A.M. -- Next Day
Total Rate(USD) 236.14*

Dr.Boost

Are you sure it's only 65 pounds? I have a Z6 shortblock that weighs 101 pounds.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

OnYx

just the block? I have a y7 bare block here and it weighs 40lbs. i cant immagine that internals weigh more than 25 lbs? ok here is the cost on it if it is 101 lbs.


UPS Ground*
Guaranteed Day-Definite***
Total Rate(USD) 67.40*



UPS Next Day Air Early A.M.®*
Guaranteed by 8:00 A.M. -- Next Day
Total Rate(USD) 297.80

traff1c

so its just missing the crank pulley and water pump... (lightend race pully and new waterpump coming soon then)... well try to weigh it and then give me a total and adress... cause i need a good block... im gonna build a bad *** bottom end to take some good boost...

Anyone got the hookups on some forged pistons / Rod combos?

OnYx

if you want i can pull all the internals out of it and just leave the pan and bolts and caps ETC still in there. that will meke it quite lighter.