Wastegate Elbow/Flanges 38MM
#1
Wastegate Elbow/Flanges 38MM
Turns out that my new waste gate is too damn tall and my hood doesn't even close now. (------- cast piece of ---- manifold)
I need either 3 X 35/38mm flanges or an elbow so I can turn it sideways.
Need it fast, so if there's no replies then Aaron Weir is getting an order.
I prefer PMs as they're much faster way to contact each other.
Here's a pic of ebay ----, I need the elbow on the left of the pic.
I need either 3 X 35/38mm flanges or an elbow so I can turn it sideways.
Need it fast, so if there's no replies then Aaron Weir is getting an order.
I prefer PMs as they're much faster way to contact each other.
Here's a pic of ebay ----, I need the elbow on the left of the pic.
#2
Re: Wastegate Elbow/Flanges 38MM
i was looking into this
http://meutek.com/php/catalog/produc...b36f996c8ba93d
but ended up buying the rev hard tubular manifold that already comes with the neck welded on
gl man hope that helps
http://meutek.com/php/catalog/produc...b36f996c8ba93d
but ended up buying the rev hard tubular manifold that already comes with the neck welded on
gl man hope that helps
#4
Re: Wastegate Elbow/Flanges 38MM
Thanks to those who responded, just made one myself today due to not being able to wait. Flanges were cut with oxy-acetylene and some random pipe was used for the elbow.
#6
Re: Wastegate Elbow/Flanges 38MM
thanks, I only put about 20% of effort into this. Flanges only took like 5 minutes to cut out and 5 more to drill the bolt holes.
Total cost = $0, all of the supplies were gotten from the schools welding shop.
Total cost = $0, all of the supplies were gotten from the schools welding shop.
Thread
Thread Starter
Forum
Replies
Last Post
soontobeDA
Turbo Parts For Sale
16
02-25-2009 11:34 PM
soontobeDA
Turbo Parts For Sale
1
04-25-2008 07:04 PM
soontobeDA
Turbo Parts For Sale
6
02-14-2008 02:45 AM