need to borrow...
#1
need to borrow...
Does anyone have a pm6 ecu, an Si intake manifold, and a distributor they would want to let me borrow? i want to do a mpfi conversion, and i want to make sure it works. BUT, im going to swap in an ls, so i wouldnt need it for any longer than it takes to make sure i have it all wired up right. I would only need it for a day or 2, and i would pay shipping to and from.
o yea, and ill need a resistor box to buy, but i havent really looked around for one, so i might be able to grab one at the junk yard.
o yea, and ill need a resistor box to buy, but i havent really looked around for one, so i might be able to grab one at the junk yard.
#2
Re:need to borrow...
i have an 88 pm6 that i have never used before. the guy said it was in good shape and i when igot it it had no cover and it was all cracked up, so i never bothered to try it. you can use it if you want. just paypal me same cash for shipping...
#3
#4
Re:need to borrow...
I have a CX intake you can have.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#6
Re:need to borrow...
yea, lol. i just want to make sure my wiring works right. It wouldnt make sense for me to shell out the cash to buy it, then turn around and sell it again. Are either manifold complete? i had a friggan complete one that i threw out a few months ago .
#9
Re:need to borrow...
Eh, mine is almost bare.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Thread
Thread Starter
Forum
Replies
Last Post
McBoost
General Discussion
0
08-24-2006 03:49 AM
bambooseven
General Discussion
7
08-17-2004 11:30 PM
steelcityhonda
Engine Management
4
07-26-2004 03:20 PM