Can someone make me a downpipe?
#4
Re:Can someone make me a downpipe?
Hmmm. I'm betting the "mercedes" flange won't fit most t3/t4 turbos, but it suppose it could. Best to check the measurements... I've got a block-off flange that will probably fit. The bolt pattern measurement is about 94mm on-center straight across the outlet. If this fits, the mercedes won't. PM me if you are interested.
#6
Re:Can someone make me a downpipe?
first off id need a flange and id have to see the car and the setup and how much clearance there are alot of factors first you just cant weld summin up and slap it on take some pics of your ront end where the dp would go and take some measurments with the manifold and turbo on and im sure i could make it for you
Thread
Thread Starter
Forum
Replies
Last Post
turboDA6
Engine Management
10
09-27-2004 07:37 AM
Civic4Sale
Turbo Parts For Sale
7
02-07-2004 12:15 AM