icemike89

Selling a turbonetics t3 super 60 that needs to be rebuilt. I rebuilt it with new bearings,seals,and a brand new standard turbine shaft and only put about 5 miles on it, but the center must be fucked or something. Both wheels look fine and it spins freely, just alot of play. Has blue backing plate, .60ar compressor housing and s-trim wheel, and a standard shaft with .48ar 5-bolt housing. First $50 shipped gets it

dot communist

do you mean the center bearing? what bearings did you replace?

rza

damn looks like a good deal. Ill let some buddies know about it.

txdohczc

do you have a picture of the turbonetics logo on the center section

icemike89

I replaced both journal bearings and the c-clips that hold them in. Im thinking the bores that hold them might need to be checked out, any place that rebuilds turbos should be able to do whatevers needed.

Yea Im pricing pretty cheap, just want it gone. Most turbonetics around this size that need rebuilt go for over $100, atleast what Ive seen. Plus the shaft on here is practically brand new and was professionaly prepped/polished before I put it in.

dot communist

ill keep you posted, but I am interested, where are you located?

icemike89

Ill get a pic in a bit. Everything is turbonetics except for the turbine housing. The ceramic coated turbonetics housing that came with it went to a buddy of mine for a standard garrett/aireasearch housing.

icemike89

Im in Baltimore, MD.

dot communist

so 50 shipped to WI? I need to sell a set of subs tomorrow, so ill let you know then.

icemike89

Yea thats fine. I usualy just say a flat shipping fee so I dont have to mess with quotes and all. If I lose/gain a few bucks between shipping prices doesnt matter to me. Unless it were going out of country then Id get a quote.

Just let me know