Talon Part out thread
I have a 92 talon i am parting out, going a completely different route with it. (V8 Inside).The engine has about 4000 miles but the guy that put it together used this damn red silicone everywhere and it leaks oil out the front cover. I bought it with a blown head gasket (had a bad wastegate). motor runs great but has a bad vacuum leak on the intake. will also take pics of the compression test before i remove it (maybe vids).
Engine specs:
6 bolt motor
1g rods
2g pistons
bored .020 over
new tps
$500 with out turbo or injectors, just long block and intake
$800 with 5spd AWD Trans

Apexi SAFC 2 comes with all wiring.
$150 shipped.

1g DSM 450 CC injectors
$60 shipped

1g crushed bov with pipe
$35 shipped

autometer boost gauge
$45 shipped

autometer narrowband a/f gauge
$40 shipped

14b turbo, very little shaft play made 14psi on that motor by 3500. no smoke
$100 shipped with o2 housing and lines.

Urethane mounts for 1g awd spd talon
only couple pics but have all of them
$90 shipped

Engine specs:
6 bolt motor
1g rods
2g pistons
bored .020 over
new tps
$500 with out turbo or injectors, just long block and intake
$800 with 5spd AWD Trans

Apexi SAFC 2 comes with all wiring.
$150 shipped.

1g DSM 450 CC injectors
$60 shipped

1g crushed bov with pipe
$35 shipped

autometer boost gauge
$45 shipped

autometer narrowband a/f gauge
$40 shipped

14b turbo, very little shaft play made 14psi on that motor by 3500. no smoke
$100 shipped with o2 housing and lines.

Urethane mounts for 1g awd spd talon
only couple pics but have all of them
$90 shipped

what motor you have. its pretty much compatible with just about anything as long as you know how to wire it. but there is always a few exceptions.
injectors will come with clips if you need them. didnt want to chop harness, but oh well.
injectors will come with clips if you need them. didnt want to chop harness, but oh well.


