So I have a lot of stuff to sell; i need storage space back and some cash to finish my LS swap in my EF would be nice. Price not set in stone low ballers will be ignored. Here it is:

Electronics:
2x-nextel blackberry 7250 clean msn/sim come w/ batteries but no chargers - both work fine $25/ea shipped
3x-merlin S720 evdo air cards -tested - clean esns $25/ea
1x-sirius stiletto s10 - very litte usage dont use it anymore - has car kit $50
1x-stilleto s50 - very little usage - has car kit $40

Car electronics:
1x-Innovate LM-1 w/ analog input, inductive rpm pickup, serial cable, analog narrow and wb out, power and batt clamps - works great sensor has low hours - bought for a friend who backed out was going to keep as a backup - not in a huge hurry to sell this $270 firm
1x-Eepromer-5 comes w/ cable and power adapter - $20


Car parts misc:
1x-Infinity q45 throttle body w/ tps $80
2x-Infinity q45 maf - tested working $60

Honda parts:
2x-d-series obd0/obd1 alt both work $40
1x-zc starter may be same as other d-series $40
1x-dohz zc non-lsd trans w/ half shaft - great condition no grinds used on my turbo D in my EF $400 w/ half shaft pickup or ship at buyers expense
1x-xtd clutch/flywheel - 6mo usage lots of life left new T/O bearing $160 pickup or ship at buyers expense

D16 parts - full engine $100 see below:
1x-d16z6 head w/ intake manifold - used but works fine solenoids included missing injectors tb, comes w/ Dizzy but its missing the guts just the housing $75 pickup or ship at buyers expense
1x-d16z6 shortblock - motor blew a HG and i drove it like that for a while so one of the bearings took damage from the water/oil mix - motor ran fine and had 185 compresson on all 4 when it was pulled but would puke coolant under boost and developed low oil pressure the last few days it was running - head and block still together will seperate if someone wants $40 for the shortblock - pickup only

Turbo stuff:
1x-b-series cast turbo manifold - possibly a/c friendly w/ a smaller turbo and tight downpipe w/ ext wastegate flange on top $60 i'm probably going to use this
1x-Turbonetics t3/t04b - T3 stage 3 turbine unknown compressor will measure when I find my caliper - little shaft play $250 - i might use this in the near future
1x-Holset h1e - rebuilt w/ OE holset parts - 18cm and 28cm housing - 18cm housing needs to be bored to work $200 pickup or ship at buyers expense


PICs coming soon and avail by request - vouches avail - all posative feedback on ebay & paypal verified for > 10yrs

Parts are in Victoria TX - u can email me computerjlt at yahoo or aim me "honda of fury" if i'm on

 

where you at

 

victoria tx in the middle of houston corpus san ant and austin

 

manifold is off the market and turbonetics turbo is gone

 

holset nice

 

thx someone buy it or sell me a smaller than 18cm housing that will fit without having to bore it out lol

 

buuuuuuuuuuuuuuuuuuuuuuuump need moneies open to offers

 

eepromer-5 ? is this a burner you say power adapter is this for a cig lighter pics please and a better desription. if it is a chip burner for a 28 pin this i might pick this up what will the price be to 37172

 

yea its a chip burner has an ac adapter and paralell cable. ill ship it to u for $25 paypal