chinoy

ANother stupid quesction asuming I have the LSU sensor.
And just want the WB O2 circuit. Do you have anything on offer.

FoundSoul

MegaSquirt PCB3.0 Kits Now Available!, The new kit is here and ready to ship! This is the latest revision of the MegaSquirt EFI system with several new features and a higher quality circuit board.

• The uprated Flyback circuitry is now onboard.
• Additional ignition trigger circuitry for Hall/Optical/VR triggers is included.
• A high current ignition driver is built in for directly triggering a coil using MSnS-E or the MS2 (when available).
• There is additional current limiting circuitry to make the units much more 'oops-proof' so that a minor wiring mistake is unlikely to damage the ECU.

Click here for more info!

FoundSoul

The LC-1 will put out a programmable analog output (actually it has two programmable outputs), so you can input it into any ECU you like. You can program the outputs for linear wideband or for simulated narrowband depending on your needs.

FoundSoul

The MSnS-E firmware will control ignition using the MS1 hardware (PCB2.2 or 3.0). You can control ignition any number of ways, distrbutor-based or distributorless by adapting the Ford EDIS system. The new PCB3 even includes a built in coil driver circuit to directly drive the coil and can be triggered by a VR, Hall, or Optical sensor.

FoundSoul

I've got LC-1 kits in stock both with and without the sensors. $199 with and $149 without.

LC-1 with Sensor -- $199

LC-1 without Sensor -- $149

J-MAN

so that means that i can use it with any datalogging program and get correct readings as long as i specify what wideband/controller i am using?

FoundSoul

Sorry I didn't see your post sooner-- I need to check and see if email notification is turned on because I didn't get anything... I was just dropping by to update the first post to add the MS2 kit availability and saw your post....

You should be able to use the LC-1 or LM-1 with any datalogging app or ECU/piggyback. Since the outputs of either unit are programmable then you can use it with anything out there and customize the outputs to match up with what's expected.

FooK

emailed you with some questions

J-MAN

i just got my wideband that i got from you hooked up and it doesn't seem to be workign. it gave me a error 8 wich means faulty sensor. the only reading it shows me is full lean or fulll rich. it worked for a few days but now i am getting some funky readings. do you sell just the sensor or know where i can buy just the sensor?

chinoy

Ok so 149 without the sensor sounds good. And something I could use.

You say you can programe it how ?
You say you can datalog the output how exactlly.
Do you have s/w that runs on a PC / Palm.
Does it store the data to onboard ram like the DIY WB02 or serial output ?