Slo_crx1

I know there's not much of a market for this ---- on here, but ---- it here it is anyway. It's brand spanking new, I hooked it up for 5 minutes to verify it works and unfortunately my Evo has shitty acoustics so I need something much much larger to do what I want. Should be good for a small setup in a hatch or crx though, and comes with all original box/packaging/manuals/screws. $50 shipped takes it, it's rated at 250watts RMS and 500 peak. Pics:




*Add on!* Figured I'd add these on for the hell of it. Trying to clear out my garage and get rid of what little Honda parts the scammer that bought my car left behind.
Piece of a cut up DC Sports 4-2-1 manifold from a B18. Not sure who'd want this, but make me an offer if you do.


Pieces from a CT-26 turbo. The center section has no bearings in it (they fell out somewhere lol) and I do have an exhaust housing for it as well. Let me know what pieces you need, the only part I don't think I have is the clamp that holds the exhaust housing to the chra.


Misc. B16a valve springs, retainers, and keepers. They're from an auto trans head. $15+shipping obo.


LS oil pump, rear main seal, 35/38mm wastegate flange, and a wg flange with a piece of pipe welded on. Holes were drilled out, tried to make it fit a t-bird t3 compressor outlet or 14b outlet. Also a section of reinforced IC rubber piping from a 1st gen eclipse. Make offers...


LS crank timing gear, B-series crank pulley bolt, LS driver's side block mount and alternator mount, stock LS FPR and a fire ring for a 38mm WG...


Decent shape B16 timing belt (less than 6k miles and can still read the numbers off it), 4 1st gen eclipse injector clips, and a set of Honda obd1 injector clips...


Unknown shape obd1 dizzy, spins well though and no cut wires/modded mounting tabs. IACV valve, and L hand rear caliper for 90-93 Integra or civic/crx si...


2 front calipers from a 91 Integra, no mount brackets...


LS T-stat housing (pipe is a little rusted so I wouldn't bother with it)...


3 B-series windage trays and 2 B-series oil pickups...


LS intake and throttle body, will seperate the throttle body...$40+shipping on the throttle body, make offer on the intake.


Known good working LS obd0 dizzy, missing cap and coil. No cut wires, no cut mounting tabs, $40+shipping



Forgot to list my location, I'm in NEPA 18407 zip code. If you need vouches then obviously you haven't been on here long. :P

Slo_crx1

Make me some offers here, just want this stuff gone. :P

Smith-02

summit racing has a HUGE pile of those 4-2-1 headers for $20/ea. roadtrip anyone?

forgot to add, there is blow-thru welds all over.

RENR

do you have and extra obd1 z6 intake air temp sensor?

Slo_crx1

I might...obd0 and obd1 are the same sensor so I know I at least have the 1 off that LS manifold, and I think I still have 1 from a friend's old d15b swap.

jdmmirage904

20 shipped on the amp

Slo_crx1

$50 shipped, it's brand new and would cost me $20 alone just to ship it. :P