HomemadeTurbo - DIY Turbo Forum - B Series Turbo stuff & MISC

I know I'm a noob, but I've been on here awhile reading around and I have verified paypal. All prices are OBO, so if you don't like the prices (I'm sure someone will disagree), give me a reasonable offer. Located in Washington 98801. Prices listed are not with shipping. As far as shipping, if it fits in a flat rate box, that's what it'll cost, the bigger stuff, will depend on weight and location. I'm in the process of building a fully built LS/Vtec Turbo set up, and it's raping my bank account, so I'm just trying to fund the project. I have a list of stuff in the wanted section that I would be willing to trade this stuff for and cash on my end.

B series t3 flange Cast manifold $85
XS Power 38mm wastegate w/7lb spring $30 SOLD
Ching Chang t3/t4 To4E turbo, very little shaft play with oil restrictor and steel braided feed line $150
3" mandrel down pipe with 3" flex pipe, heat wrapped, 5 bolt t3 flange, o2 bung, flange for dump tube, and flanges $80 SOLD
DSM 450's $65 SOLD
(4) Resistor Boxes with plugs $15 each
Motorola 2.5 bar map sensor with pig tails $25 SOLD
B18B1 Complete head, with valve cover, no dizzy $100
B18A1 Complete head with valve cover, no dizzy, $70
B18A1 Bare Block with main caps. Good block, was gonna use for a spare $75
(2) OBD1 alternators $50 each
OBD0 alternator $40
(6) 4 wire o2 sensors $23
(3) Tps sensors $20
(4) OBD1 map sensors $15
GSR oil Pump $50
B series tapped oil pan $40
SI Wheels got some curb rash, but still look good. 2 center caps are drilled for extended wheel lugs $100SOLD
EG half size radiator w/fan (came out of a dx) $35

Like stated above. .ALL PRICES ARE OBO. . . I have pics of a lot of this stuff, so pm me if you want a picture of something specific.

Here a picture of the turbo, manifold, wastegate, and downpipe setup

Attachment 21212