91' Turbo'd Civic for best serious offer
#1
91' Turbo'd Civic for best serious offer
Car doesn't run. Engine is good. Possible bad ground. Master solenoid ticks a lot and engine dies.
This is a 1991 civic DX with a D16Y7, a DSM turbo and front mount inter-cooler. This car is a beater. Spray paint, paint job. Chiseled and sanded out noise dampening tar and stripped interior for weight reduction.
List of mods are as follows:
Things that come with the car if you want them:
*Please note that the rear disk brake conversion was not yet done with the picture was taken of the coilovers.
*Needs a new clutch
*Tranny leaks a little - needs rebuild
Photobucket is messed up right now. Pulled the links of these pics off other threads...what other image hosting site should I use? Please email for pics as well.
San Jose, CA
Eric
est.piech@gmail.com
408-540-4641
This is a 1991 civic DX with a D16Y7, a DSM turbo and front mount inter-cooler. This car is a beater. Spray paint, paint job. Chiseled and sanded out noise dampening tar and stripped interior for weight reduction.
List of mods are as follows:
- D16y7 swapped
- 2g eclipse DSM turbo (oil + water cooled)
- front mount intercooler
- DSM 450cc injectors
- hi flo fuel rail + pressure regulator
- Integra rear disk brake conversion
- Integra brake booster
- Skunk2 coilovers + homeade camber kit
- Sparco Seats (passenger reclineable, driver stationary)
- Battery relocated to trunk (brand new battery)
- OBD1 conversion
- Chipped ECU w/ Motes Ostrich and Hulog
- eCtune license (transferable with $25 fee)
- AEM wideband
- Homemade oil catch can
- 8lbs Fidanza flywheel
- Magnaflow muffler with straight pipe cat-less
- New axles
- Viper alarm
- Power locks
Things that come with the car if you want them:
- D16Y8 VTECH head. (the wireing harness and CPU are ready to plug and play this this head)
- FJ distributors bottome end kit including YCP vitara low compression 8.8:1 pistins, water pump, timing belt, ACL bearing and all gaskets for rebuild.
- Acura 15 inch allow wheals w/ sticky tires and wheel lock
- Jegs weld in 8 point roll cage
- Fender bracers
- AC inverter for your laptop
- Ebay boost ***
*Please note that the rear disk brake conversion was not yet done with the picture was taken of the coilovers.
*Needs a new clutch
*Tranny leaks a little - needs rebuild
Photobucket is messed up right now. Pulled the links of these pics off other threads...what other image hosting site should I use? Please email for pics as well.
San Jose, CA
Eric
est.piech@gmail.com
408-540-4641
Last edited by ThaCrow; 01-05-2013 at 02:38 PM.
Thread
Thread Starter
Forum
Replies
Last Post
staticchmbr
Turbo Parts For Sale
87
04-05-2008 02:55 PM
noscivic01
Turbo Parts For Sale
5
05-30-2006 10:10 PM