con

--------------------------------------------------------------------------------
Quote from: Fellipe on Today at 09:51:23 AM
I like to lick the fingers of gay men. Quit hating because there's nothing wrong with it and don't knock it till you've tried it.


hahaha

redex04

where u located

stillnoturbo

Fellipe

Baltimore, Maryland. The car is in Cecil County near havre de grace

2G6

I pm'd you about the 16g's. If you want to sell one or both you should pm me back for chrissakes.

Fellipe

Engine: D16Y7 out a 2000 honda civc dx (NOT IN CAR!! The piston ring blew and there was low compression on one of the cylinders so I swapped it for a temporary D15B8 which you will get as well and it's currently in the car.)
fuel pressure gauge
B&M adjustable fuel pressure regulator
DSM 450cc blue top injectors with resistor box (not installed because it's too much for the D15 without a turbo)
Bosch Platiuim spark plugs
DSM turbo 14b (May need a rebuild, not sure)
DSM 16G turbo (BRAND NEW! I have the receipt and it has less than 50 miles on it)
Mitsubishi TE04H (it's out of those turbo chryslers back in the days and I think it's been rebuilt, I never used it so i'm not sure)
custom exhaust with magnflow muffler (no cat)
Intercooler and piping
255 walbro fuel pump
new oil pan and gasket
new brakes and rotors (cross drilled and slotted as you can see from the pictures)
new axles
B&M short Shifter
Hornet Alarm (no longer installed)
SAFC2 (no longers intalled because of the current motor, there is no need for it without the turbo)
triple pilliar with oil pressure, boost, and water temp guage. Black smoked
P74 ecu (not installed) and P28 ecu with JUN chip
new sony xplod speakers
toykico adj shocks (front struts are blown,but as you can see from the pictures I have replacements for the front and the rear as well if you would like to take it upon yourself to change it)
Rear drums are new as well
MSD Cap
MSD Blaster SS COil
MSD 8.5mm super conductor wires
Fuel cut off switch
Leather seats (the driver seat is a little rough)
I have the stock headlights that will be included as well
I used the stock Y7 manifold to fit the turbo (I just made a plate to bolt the turbo onto and the plate mounted to the manifold)
I have an LS throttle body that is not intaled
HKS Turbo Timer
The transmission also came with the D16Y7 motor so it's a much newer transmission

That's all that I can think off the top of my head without going and looking to make sure that i didn't miss anything. You can look at the pictures to see if I missed anything. THe car does run right now, but it's running a little bit rough since I can't get the idle right, but I'm working on a fix for that so it should be done by sometime this week. The body has 200k on it, but as you can see, just about everything has been replaced. The y7 has about 60K on it, but it does need to be rebuilt because of the piston ring and the b8 has about 80 ish, I don't remember too well (it's from my buddy's swap).

any quesitons PM me

stillnoturbo

Hey,


















































your gay

2G6

AHAHAHAHAHA!

2G6

I tried to buy one of the 16g's off him and he said that he'll only sell all of it together. I didn't even bother responding to that nonsense. stillnotturbo I think nailed it though. We have a homosexual in out midst fellers.

stillnoturbo

Yeah I asked him about the 16g caues I'm not looking through all his ------- pictures. I mean the car doesn't run but he's like...blah blah blah...I'm not parting it out. He's like I can get you a new 16g if you want. ------, take a air nozzle and stick it in the inlet part of the turbine housing and get that ****** spooling and then stick your little peter in the intake section of the compressor housing....salad shooter! Go fist yourself you worthless piece of ---- of the "homo"sapien species.