TunerToys

Get your's here....

http://tunertoys.zoovy.com/product/R3-5394-AH

Thanks form Craig

lkailburn

are these the new redesigned ones? the ones that don't need machining to fit vitaras?

-Luke

ososlohatch

i have bought alot of stuff from you craig and you've been a awesome businessmen, i have prolly ordered 3k+ in parts(stuff for other peoples cars to) , i recently asked about buying a ram horn mani and rods from you and asked what kind of a deal i could get since you didnt offer hmt diiscounts, your response was a free t-shirt. needless to say your sticker was taken off my car and my eagle's are on the way to my door. thanks for all the stuff in the past and hope your doing well with all the new pricing

TunerToys

I totally have to apologize for that. Without turning this into a poor me thread, I'll just say that I had a rough few days last week, and was not in a charitable mood. I'm afraid that I allowed my frustration to show that day, and you were not the only one to get hit by it. I have sent you a PM, in an attempt to mend what I may have broken.

Craig

TunerToys

You are correct. In fact I pulled a set of FJTs Vitaras off the shelf, and test fit a pin into the rods this morning. It was a pretty decent fit. I also checked the pin end width between the piston pin bosses, and that looks good too.

Craig

SDRAWKCAB

Craig Your the man
i want rods now!
hold a set for me untill friday when i get my pay check!

Chaos325

does the new design require to notch the block still?

m0nee

hMmm... so what about the Eagle H-Beam that I just recently bought off Ebay? Are they going to need some mechining to fit my CYP pistons?

ososlohatch

no, eagles aren't made in china