wtf...i tried tightening my toilet to the floor (it rocks a bit), but the ------- nuts/studs just spun in place with minimal torque. I have zero experience with toilets and how they mount, anyone have any insight? I really dont feel like ripping this bitch out just because it wobbles.

 

jb weld

 

There are wedges you can buy at home depot, lowes, ect.... they are in the plumbing department. Good luck, you don't have any leaks right??

 

its gonna start leaking if it keeps wobbling.. but yeah use those shims to prop the toilet.. keep it from wobbling..
then run some plumbers caulk arround the entire bottom of the toilet..

 

clear silicone all the way around the bottom gap (remove old if applicable)
apply new coat make sure to squeeze in to the gap.
let dry for a day or 2
if you must sit during drying time make sure not to rock it

 

so basically i should just ignore the fact that the bolts/studs/whatever arent really tight? It doesnt leak, my initial idea was just to shim/caulk it but i was worried since the bolts arent very tight.

 

as long as the wax seal is good an not leaking it should be fine

 

you can shim it, but my money says your wax ring is about shot.

 

take a **** while standing and hover poop

duh

 

haha i already thought of that...plus there is another bathroom for number 2