Get your's here....

http://tunertoys.zoovy.com/product/R3-5394-AH

Thanks form Craig

 

are these the new redesigned ones? the ones that don't need machining to fit vitaras?

-Luke

 

i have bought alot of stuff from you craig and you've been a awesome businessmen, i have prolly ordered 3k+ in parts(stuff for other peoples cars to) , i recently asked about buying a ram horn mani and rods from you and asked what kind of a deal i could get since you didnt offer hmt diiscounts, your response was a free t-shirt. needless to say your sticker was taken off my car and my eagle's are on the way to my door. thanks for all the stuff in the past and hope your doing well with all the new pricing

 

I totally have to apologize for that. Without turning this into a poor me thread, I'll just say that I had a rough few days last week, and was not in a charitable mood. I'm afraid that I allowed my frustration to show that day, and you were not the only one to get hit by it. I have sent you a PM, in an attempt to mend what I may have broken.

Craig

 

You are correct. In fact I pulled a set of FJTs Vitaras off the shelf, and test fit a pin into the rods this morning. It was a pretty decent fit. I also checked the pin end width between the piston pin bosses, and that looks good too.

Craig

 

Craig Your the man
i want rods now!
hold a set for me untill friday when i get my pay check!

 

does the new design require to notch the block still?

 

hMmm... so what about the Eagle H-Beam that I just recently bought off Ebay? Are they going to need some mechining to fit my CYP pistons?

 

no, eagles aren't made in china