Map Sensor Wiring - Which Is 5v/Reference/Ground? quick n easy
Thread Starter
1.0 BAR
Joined: Feb 2006
Posts: 640
Map Sensor Wiring - Which Is 5v/Reference/Ground? quick n easy
Trying to wire a 2.5bar map sensor and dont have any voltmemter to check voltage (wouldnt know how anyways)
The car is an 88 crx si and I need to figure out which wire going to the map sensor is the 5v, reference and the ground
Does anyone have it off hand? Id appreciate it
The car is an 88 crx si and I need to figure out which wire going to the map sensor is the 5v, reference and the ground
Does anyone have it off hand? Id appreciate it
3.0 BAR
Joined: Mar 2004
Posts: 2,039
Re: Map Sensor Wiring - Which Is 5v/Reference/Ground? quick n easy
Haven't installed mineyet but i was going to follw these instructions
http://www.hondata.com/tech3barmap.html
http://www.hondata.com/tech3barmap.html
Wire Sensor Code B Series RSX-S
GND A Green/White Green/White
MAP signal B White Green/Red
5V C Yellow/Red Yellow/Red
For verification check inside the Honda Map sensor plug. The pins may be labeled with V O G - for Voltage, signal and ground.
GND A Green/White Green/White
MAP signal B White Green/Red
5V C Yellow/Red Yellow/Red
For verification check inside the Honda Map sensor plug. The pins may be labeled with V O G - for Voltage, signal and ground.
Thread
Thread Starter
Forum
Replies
Last Post
95civicLX
Engine Management
6
Jul 5, 2006 06:30 PM
typer
General Discussion
12
Nov 26, 2005 11:13 PM
