i was thinking about the article where the devcon liquid aluminum was used to fill the block, and wondering to myself, why couldn't you use that to make some homemade solid mounts? anybody see a reason this wouldn't work?

 

welcome to the 21st century this has been covered oh iono.. 213609872346 times, there's even a writeup in the tech projects. https://www.homemadeturbo.com/tech_p...s/poly_mounts/

hell, i even did a write up on it. noob

grab a rope

 

He is talking solid, not poly you jackass.

 

SOLID being the key word. i have homemade poly mounts but i think solid would do better for less flexing, and i'm on a budget so hasport/equivalent mounts are out of the question.

 

well yea i dont see why not.

get a bucket, throw in a layer of salt, put the mount in it, put salt/sand around the mount, fill the mount with devcon. i dont see why not

 

just wondering if the vibration would cause it to crack...

 

use jb weldd

 

solid mounts are horrible idea ... do to vibration .. horrible horrible wheel hop and more than likely breaking axles on a daily biasis

 

i would worry about that too, but whats the purpose of block guards- to keep the sleeves stable at 7000 rpm with 15psi being crammed into them

it'd be a good test

 

even using a place racing crossmember and ES bushings to make my torsion bars into traction bars, and driveshaft shop stg. 2 axles?