im wondering if someone can tell me the part number for the bottom seals that i would use for the dsm injectors. im putting them in a 95 gsr motor. either the part number for honda/acura or napa, i just want to make sure that i get the correct part. thanks for the help.

 

I don't have a part number. Just use a dremel tool with sanding strips and enlargen the ones you have. You will have to do the same wih the new ones you buy from a parts strore.

 

yea i was thinking the same thing...but they have different heights. so what i was thinking that i would get two sets and take to pieces and trim to fit to make them the same height as the ones they used on the write up. i already started on making the hole bigger, but in my case it was harder than it looked. how high of an rpm setting should my dremel be set at for a job lke this? i gotten pretty frustrated with this being that it is the only thing besides the tuning that i have to finish on my turbo setup. thanks for your time so far.

 

seriously,

put dremel in the hole whizz it round for a couple of seconds, job done

have a nice tight fit, some people dont even bother dremelling the holes out they just put a blob of oil in the holes and tighten the fuel rail onto them

 

will do.

 

I didnt even have to use a dremel, took me 30 seconds to squeeze them into the stockers

 

hmmm..i just might try that first.

 

napa updated the part, at least when i got mine, now they are a softer black rubber and its hard to dremel, bu i still got it done.. maybe i didnt need to even do it tho, id just force them in like dude did

 

what did you buy? was it the kit? how much did you spend on it? just curious. thanks

 

dremel. Buying new seals is retarded. :1