dsm injector install...
 

im wondering if someone can tell me the part number for the bottom seals that i would use for the dsm injectors. im putting them in a 95 gsr motor. either the part number for honda/acura or napa, i just want to make sure that i get the correct part. thanks for the help.

Re: dsm injector install...
 

I don't have a part number. Just use a dremel tool with sanding strips and enlargen the ones you have. You will have to do the same wih the new ones you buy from a parts strore.

Re: dsm injector install...
 

yea i was thinking the same thing...but they have different heights. so what i was thinking that i would get two sets and take to pieces and trim to fit to make them the same height as the ones they used on the write up. i already started on making the hole bigger, but in my case it was harder than it looked. how high of an rpm setting should my dremel be set at for a job lke this? i gotten pretty frustrated with this being that it is the only thing besides the tuning that i have to finish on my turbo setup. thanks for your time so far.

Re: dsm injector install...
 

seriously,

put dremel in the hole whizz it round for a couple of seconds, job done

have a nice tight fit, some people dont even bother dremelling the holes out they just put a blob of oil in the holes and tighten the fuel rail onto them

Re: dsm injector install...
 

will do.

Re: dsm injector install...
 

I didnt even have to use a dremel, took me 30 seconds to squeeze them into the stockers

Re: dsm injector install...
 

hmmm..i just might try that first.

Re: dsm injector install...
 

napa updated the part, at least when i got mine, now they are a softer black rubber and its hard to dremel, bu i still got it done.. maybe i didnt need to even do it tho, id just force them in like dude did

Re: dsm injector install...
 

what did you buy? was it the kit? how much did you spend on it? just curious. thanks

Re: dsm injector install...
 

dremel. Buying new seals is retarded. :1