it would be the same than Impact gun air ?

http://cgi.ebay.com/ws/eBayISAPI.dll...DME:B:AAQ:US:1

i would like to change the timing belt but the next month (i want to save money for to buy more stuff this (besides the ecu by xen..) ..

i have seem two write- up about to change timing belt (besides factory service manual) but my family say that not , i'm wouldnt be to able for change it.. my brother neither.. , i would like to change.. but.. is it very very very hard? i know that to remove the crank bolt is very difficult..i have some tools as torque wrench ,ratchet, screwdriver..spanner, allen wrench and the next week i going to buy two jack stand ...

the bad part is that i havent garage (though my father yes but is very little , but he live far to me but..).. so i think that i would can to do it in the street?

I am disappointed

 

if u take your time u can probably do it. i dont know if the elec gun has the power to undue a crank pully bolt, but there are ways to do it w/ hand tools

 

yeah but i havent a breaker bar , but when i go to buy the stand jack i hope to find a breaker bar (what do i need more?) .. i have time (for my car all time :P).. but i need encourage myself because i think that i have not help of none.. (my friend say that he doesnt dare to do it with me.. )..

i need too a special tool for to move the engine to TDC right? for example.

http://cgi.ebay.com/ebaymotors/Honda...36365499QQrdZ1

or is it not necessary?

 

id say you should take it somewere to have it done. its not that its hard but maybe you should start smaller.

 

eletric ones suck bad i have one at my welding shop no good and its a milwakie

 

what you means with that i should start smaller?

teg91 , ok then all i can do is to do with hand tools..

 

I have tried loosening the crank bolt it is a bloody nightmare. Tried using air impact gun (although they are not hte best in the world) it didn't budge. Then I got hold of the crank holding tools and an extra breaker bar, using my whole body weight even try jumping on it (as I have the engine out) still not loose.....

But give it a bash first before giving up.... As it would be so satisfying to get that bitch of a bolt off

 

Don't waste your $$ on the electric ones. And theres no excuse for not owning a breaker bar, its a piece of pipe, the longer the better too.

 

My IR gun at the shop has 1,000 ft lbs of torque, i can undo anything

 

My dad can beat up your dad. worthless post retard. ^^

They are very handy. Just like a corded drill Vs. a cordless. Not the same power, but way more portability.

I would not spend the money on an electric impact right now. Get yourself an 18" bar and some pipe, problems solved. I don't own an impact and there is nothing on the car I can't remove. Sure it is harder, but in the begining start small on the tools.