Anyone know of a writeup on swapping a D16Z6 into a CRX HF? I can find a couple writeups but none of them are specific to the HF.

Basically, I need to know the wiring for it, and I'm pretty sure that I have to swap out the hubs to the DX/SI hubs, right? Any other differences between swapping a Z6 into a DX/Si and a HF?

 

Same as doing the swap on si except for the knuckle and hubs that you need to change. Depending whether or not you want to stay obd0, the wiring is the same as the si (no need to worry about it), unless you want to convert to obd1.

 

you dont need to change the hubs if you keep the hf axles and yes Its been done numerous times I ahve done it atleast 10 times in cars I have done swaps in

 

if I keep the hubs and HF axles then what tranny should I use?

 

si cable only choice if you want the car to run some what fast

 

I was hoping you would say SI cable. What wiring do I have to change on the HF engine harness? I want to convert to 0bd1 with obd0 to obd1 conversion harness and run a p28, am I going to need the Z6 engine harness to do that?

 

Depending on the adapter harness you will need to add some wires


either talk to chris aka xenocren

or rywire.com

about the harness