D16Z6 into a CRX HF
#1
D16Z6 into a CRX HF
Anyone know of a writeup on swapping a D16Z6 into a CRX HF? I can find a couple writeups but none of them are specific to the HF.
Basically, I need to know the wiring for it, and I'm pretty sure that I have to swap out the hubs to the DX/SI hubs, right? Any other differences between swapping a Z6 into a DX/Si and a HF?
Basically, I need to know the wiring for it, and I'm pretty sure that I have to swap out the hubs to the DX/SI hubs, right? Any other differences between swapping a Z6 into a DX/Si and a HF?
#2
Re: D16Z6 into a CRX HF
Same as doing the swap on si except for the knuckle and hubs that you need to change. Depending whether or not you want to stay obd0, the wiring is the same as the si (no need to worry about it), unless you want to convert to obd1.
#6
Re: D16Z6 into a CRX HF
I was hoping you would say SI cable. What wiring do I have to change on the HF engine harness? I want to convert to 0bd1 with obd0 to obd1 conversion harness and run a p28, am I going to need the Z6 engine harness to do that?
Thread
Thread Starter
Forum
Replies
Last Post
hotintegranights
Turbo Parts For Sale
6
05-28-2005 10:57 PM