help please honda civic
3.0 BAR
Joined: Jul 2004
Posts: 4,028
Re: help please honda civic
Cut the exhaust manifold down to a useable size and weld a T25 on it.Then run some pipe to the air intake for the carb and silicone,jbweld the air housing till its air tight and will hold pressure.Proceed to richen the ---- out of the adjusting screw on the carb.Now at this point go inside and grab your video camera and then go blow a rod straight out the block.I would not even worry about oil lines as the motor probably will not last long enough for the turbo bearings to cook.
0.0 BAR
Joined: Oct 2005
Posts: 0
Re: help please honda civic
Originally Posted by 90dx
Cut the exhaust manifold down to a useable size and weld a T25 on it.Then run some pipe to the air intake for the carb and silicone,jbweld the air housing till its air tight and will hold pressure.Proceed to richen the ---- out of the adjusting screw on the carb.Now at this point go inside and grab your video camera and then go blow a rod straight out the block.I would not even worry about oil lines as the motor probably will not last long enough for the turbo bearings to cook.
Thread
Thread Starter
Forum
Replies
Last Post
98dc2gsr
Hybrid/Tech
2
Mar 4, 2012 04:58 PM
racepak
Engine Management
0
Dec 1, 2006 06:46 AM
2000vsm
Forced Induction
10
Jul 17, 2003 07:21 PM
