I have been trying to get my car running on Uberdata. I followed the Base map how to , but if I use that file (basemap3 attachment) I get a solid CEL.

But I can use this BIN (B18B1LS7psi550s3in attachment) from the Xenocron list and its fine...

any reasons for that ?

Only real difference I could see was that with the formula in the how to I came up with a value of 50 for my fuel multipliers but in the borrowed BIN they are set to 100 .... ?

 

start by opening the stock GSR bin....always works for me...

 

yup this was the solution to my problem as well..

 

importing is your friend. What version of uber are you using?

 

well, at least you tracked the problem down.

 

1.7

I'll try making a new base map starting with the GSR map.

I think so. I hope so. Finally got it to work after we pulled the main as you suggested, and just cleaned it and put it back. After that it worked , but only with the borrowed ECU and borrowed chip. My chip wouldn't work in either ECU, and my ECU wouldn't work with either chip.

So we desoldered my socketing and resocketed it. And I bought a couple chips from a local guy. Now it works with my ECU and new chip .... but like I said only with the BIN I down looaded, not my base map. I am going to try making a new map starting with the gsr BIN.

Thanks again for all the help.

 

Ok tried the StockGSR bin along with the basemap how-to ... same deal , solid cel. I have just been modifying the imported map and saving the changes for now, but I would like to make my own basemaps at some point ... any thoughts?