delete thank you

 

iahve a white face 2 1/16 autometer gauge electric with sender

 

i have been to a few and they only have bolts no studs
tell me where did you guys get them from ?

 

Check this out, im assuming you absolutely need studs because theres no room for a bolt to fit? So instead of welding studs and then having to grind it down so the flange and gasket can sit right and then still possibly having a leak, Just tap the holes and use bolts, if you do go the studs route, you can still tap the t3 flange and make sure the turbo side stud is a smaller diameter because you wont be tapping that. I have some studs around here, they are perfect for t3 tubos for weld in application. Let me know if you need some.

 

no i am not going to weld them in
i just need good studs that can handle heat, not ones for putting a swing set together with