if you have any saved on your computer or on a web page, post some pics or your crx/civic fmic without the bumper on, i mainy want to see how you guys mounted them...

 

i dont have pics yet but I can describe how mine was mounted, cause I did it today.

Across the top and bottom of the JRC 8" there are three bolt locations that stick out of the intercooler, about 7/16" wide.

I drilled a hole dead center under the beam in the center, where the top of the intercooler sits, then i drilled on on each side of that, exactly where those bolting locations on the intercooler are, so that the intercooler slides up into those holes. Then I used the tabs that came with it to bolt to two stock honda holes in the lower core support beam. Just used a couple honda 10mm bolts, simplest install i ever dealt with. 8" hangs way low tho.

I'll get pics tomorrow when there's daylight.

 

i just ziptied it on there to hold it in place and then drilled some holes for bolts, hope this helps.

 

I just plamsa cut my bumper support, and bolted it right in. Fits likea glove. Plan on getting the 8" to fill the gap on teh bottom now.

 

there is mine

its pretty self explainatory on the mounting.. if you don't understand.. the tabs on the top are bolted, end of story

 

it was too wet out to get under my car but this is what i got

 

Thats a pretty clean rex :P

 

^^^

I wish my CRX was that clean...

 

This summer's setup.

Old setup