if that your car. i feel bad for you

 

A Picture is worth a thousand word, and you ran that engine, that alot of bad F@ckin words!!!

That isn't your built ZC is it? If it is I hope you just installed and haven't cranked it yet! If you did and want to give up I'll buy any unbroken hardware!!!!(Pistons?ROds?)

 

jumped a tooth... Or two, or three.

 

dayum gina!!1 looks like your tensioner is loose.....sucks man..hope you fix it and hope you didnt ---- anything up...

 

Shitty dude. Dont give up hope, things may be ok.
I had my B16 belt snap during a WOT run and while it was on the high cam. Put a new one on and everything seemed fine. Pulled the same vacuum at idle and ran and drove the same.

 

did you use KY to lube that bitch up because you are FUCKED

 

Thats why I keep it simple with my single cam

 

no this isn't my built zc but it might be built in a few days

how it happened was i was running 450ccs and then i tired setting up TE and when I put the dizzy on it was 180* off, so it just flooded the ---- out of the motor, i then turned the dizzy around turned it over once and it ------ backfired hardcore. then the belt was off

i fixed the belt, turned it over twice and it backfired again (stock injectors w/ pm or pg7 whatever out of a teg)

im not worried about my valves and ---- cuz this isn't a zero clereance motor so it isn't that big of a deal.

there is a ---- load of tension on the belt so i dont know how the hell it is doin this ----