Notice anything wrong in this pic?
|
Re:Notice anything wrong in this pic?
if that your car. i feel bad for you :'(
|
Re:Notice anything wrong in this pic?
A Picture is worth a thousand word, and you ran that engine, that alot of bad F@ckin words!!!
That isn't your built ZC is it? If it is I hope you just installed and haven't cranked it yet! If you did and want to give up I'll buy any unbroken hardware!!!!(Pistons?ROds?) |
Re:Notice anything wrong in this pic?
jumped a tooth... ;) Or two, or three.
|
Re:Notice anything wrong in this pic?
dayum gina!!1 looks like your tensioner is loose.....sucks man..hope you fix it and hope you didnt ---- anything up...
|
Re:Notice anything wrong in this pic?
Shitty dude. Dont give up hope, things may be ok.
I had my B16 belt snap during a WOT run and while it was on the high cam. Put a new one on and everything seemed fine. Pulled the same vacuum at idle and ran and drove the same. |
Re:Notice anything wrong in this pic?
did you use KY to lube that bitch up because you are FUCKED
|
Re:Notice anything wrong in this pic?
Thats why I keep it simple with my single cam ;)
|
Re:Notice anything wrong in this pic?
no this isn't my built zc but it might be built in a few days :)
how it happened was i was running 450ccs and then i tired setting up TE and when I put the dizzy on it was 180* off, so it just flooded the ---- out of the motor, i then turned the dizzy around turned it over once and it ------ backfired hardcore. then the belt was off i fixed the belt, turned it over twice and it backfired again (stock injectors w/ pm or pg7 whatever out of a teg) im not worried about my valves and ---- cuz this isn't a zero clereance motor so it isn't that big of a deal. there is a ---- load of tension on the belt so i dont know how the hell it is doin this ---- |
All times are GMT -5. The time now is 11:29 AM. |
© 2024 MH Sub I, LLC dba Internet Brands