ok, last time i tried to burn a chip it was UV erasable and i was trying to electronically erase it .. (derh) but now i got a few AT29C256's and my batronix prog-studio wont let me burn past hex 3a dec.58 .. it says that the IC data is NOT equivalent to the editor data. any help?

 

did you change the setting on the program. You need to specify what kind of chip you are burning.

 

Chip in burner wrong?

 

yes, set the program to burn a 29c256 and set the jumpers as shown on the diagram, and i put the chip in the right way, pin one on pin one... closest to the lever.

 

Umm...it should look like this:



http://www.boosted-hybrid.com/viewtopic.php?t=560
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

thats the willem burner... i have the batronix EEPROM burner v 2.3 mine looks different

 

Wouldn't the chip still go in the same way?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

ill post a pic.. and try to get close enough so you can see the number on the board that tells you where to put pin 1

 

it should go just like the pic on the Batronix shows.... you've got it the right way, i'm sure.

sometimes prog-studio will give that error if some of the values are messed up in turbo edit.... (possibly to low on the fuel table. follow xenocron's write-up of how to make a base rom, posted as a sticky in this forum. it will work eventually, and will say that the burnt chip is equivelent to the rom.

keep on trying..... you're on the right track

 

thats what mine looks like

like what the pic says.