Hi, my ecu is already chipped for uberdata ( i did it myself, not too hard!). J1 is not jumped because my turbo is not on my car yet...

I played around with uberdata 1.7 and did a basemap for my future setup ( going in in 2 week)
What im wondering is if my "bin" is ok to run for the first time... i know it wont be the "bin" i'll be running because i'll have to tune it but in general, i want to know if my map are decent.

my "ghetto" setup:

Civic si 93 with a stock d16z6 65'000miles (standard)
Std Manifold with an adapter plate
Rhb5 - mazda mx6 running 7.5psi (really small turbo)
Dsm smic
Dsm 1gen bov
Dsm 450cc, with resistor boxes
2¼ exhaust piping all the way
Custom charge pipe ( from a CaI and big radiator hose... i know im cheapass)
Uberdata... hehe!
A/F gauge
Boost gauge
Misc stuff... oil line, water line...

thank you for helping me

here is the link
http://membres.lycos.fr/labatt50/D16z6-rhb5-450cc.bin

 

Looks pretty decent. Is this a raw basemap you created? Also, do you have any source of a wideband or dataloging? Disabling closed loop for your tuning purposes might be of some benefit.

 

it will be my basemap once the turbo gets in...
For now i have not access to a wideband... i might have dataloging in couple of month ( i'll buy a a laptop for this) but for now... only my a/f gauge

And for the close loop... i didnt even know about this
but i'll disable it

 

It's more for tuning reasons, but since you don't really have any means to fine tune yet i'd just leave it enabled for now, but, as a starting point I feel you'll be alright.
You may want to bump the fuel efficiency to 120 and retard the timing a slight bit more until you can see whats really going on, but I don't think you'll have any problems. Just keep an ear out for any signs of detonation (just in case) and let us know how it goes.

 

thank you trance, you were the only one to help me with this! I own you a beer dude!

 

How 'bout a Labatt Blue (Canadian beer)

 

...
what about a Coors light?

 

Bahaha Awesome.