okay, I'm in the proccess of cutting the blk/yell wires from the junction connector, but there are 8 wires. and there all blk/yellow which 4 do i cut?the right side or left side(lookin from the front of engine bay) can anyone give some pics or show me which 4 blk/yell wires on that harness? thanks

 

http://www.hondata.com/techinjectorwiring.html
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

nice!!! thanks dr.boost that ---- helped out big time. Time to go cut and solder

 

Just a little warning/tip. Test the wires to make sure they are actually going to the injectors before you cut them. I have heard of some models being different, so it would be a good idea to check first(coninuity).
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

Ok this may seem like a stupid question but before I get flammed I read through the faqs. I couldn't seem to find out what kind of resistor box to get. Is there a certain one I need to pick up? Or just any resistor box? Take into consideration that wiring of a car is one thing I have problems with...

 

Any one from a CRX will work fine. You can also use 10ohm 10 watt resistors inline with the injectors to avoid the entire resistor box situation. It's cheaper too.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

A resistor box out of an OBD0 Integra or Civic will work perfectly.

 

My car is a 94 so obd1, sorry should have stated that first. So do I still use the obdo teg or civic resistor box?

 

Thanks Doc, missed your post, I think that would be better for me. Can I get those at radio shack?

 

Yes sir.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote