First off i know im in the wrong place for this question. But im in the process of doing this and theres less people in fuel management so its taking longer

I bought DSM injectors and harness and im trying to install them in my 98 PRELUDE the harness's dont snap together like someone on here said they would. I heard i need to run one wire to the resistor box and one to the ECU but i didnt think my car had a resistor box, i thought i could just splice wires and put them back together. I do have harness's from the DSM it was taken out of. shouldnt i just be able to cut the wires to the prelude injector splice them to my DSM wires and put the DSM harness on and put it back together?

 

You will need a resistor box from a crx or inline resistors due to impedance. You can find that in the FAQ. If you have the clips for the dsm injectors, I would try splicing them in to your existing wiring. I have blue top dsms and they plugged right into my crx si. I've heard some need a tab broken off to fit correctly but didn't have to do that on mine.

 

i wanna splice them in to my existing wiring. And i read the injector install in the FAQ's it tells me about a inline resistor which i dont know where it is or if i need to get one. I want to splice right in to the existing wiring but i dont know what colors should go to what.

 

Dude, you're seriously getting on my nerves with this injector post.

You have a thread with this already there. EM is not slow, you're jsut refusing to accept the advice which numerous members have given you.

You've already been told what to do, we're done with this thread.