i have been calling all the shops in my state. and most of them want a list of parts that i want to use for the build up!!!
i want to go turbo and i know that the B20 has week sleeves! when i mean "go turbo". i mean like min.13psi and up!!!
i might go crvtec. i'm not 100% sure yet.
so, can anyone give me a list of the parts(with name of them)that i'll need? and with the crvtec setup?
thanks

 

So basically you want info on how to make a B-series last at 13psi?

1. Sleeves (AEBS/Golden Eagle/RS mach/Darton) make sleeves
2. Pistons (Wiseco/J.E/SRP/Arias/KB/Endyn) c/r 9.0 - 10.0
3. Rods (Crower/Eagle/KB/Full-Race/or even stock)
4. Management (AEM EMS/Hondata/Zdyne/Motec/Accel DFI/Speedpro/Haltech/or DIY GD/Turboedit)
5. Turbo (T3/T4 any spec, the larger the better)
6. Intercooler (Tyrus IC/Customcoach/Greddy/Whatever any IC)
7. Manifold (Custom/Sparks Racing/Rev Hard/Full Race anything)
8. Wastegate External (Tial/Delta/Innovative/HKS/Greddy) 35-45mm
9. Injectors (450cc's and UP!)
10. IC Piping / DP (custom 2 1/2 and up!)
11. Clutch (6puk disc Sprung hub/Race disc ACT/CM/Action)
12. LSD (Kaaz/Quaife/Factory) or cheapies (Twin Trac/PhantomGrip)


Well, I hope that gave you a quick idea, your looking about 5-7000 bucks for everything if not more.

Jeff

 

92-93 gsr B17 crank
would make it nice.

 

Considering it would take displacement away when using a b17 crank, and they are incredibly rare to find, IMO not worth the time, at all

 

yes that's what i was looking for!
right now i'm only concerned about the engine build up!
so all i need for the engine build up is:
1. Sleeves (AEBS/Golden Eagle/RS mach/Darton) make sleeves
2. Pistons (Wiseco/J.E/SRP/Arias/KB/Endyn) c/r 9.0 - 10.0
3. Rods (Crower/Eagle/KB/Full-Race/or even stock)
and rebuild the hole engine
is there anything else?
i want make sure it can handle min. 13psi up to the 20's psi!!!
and what about the head if i go crvtec? will i need to do anything to that besides the usual for the crvtec swap
also, i went to hondata's web site. and i can't find that they support the B20z!?! or the 90 integra ls 5 speed ecu!?!(which is what i have!)
so, which engine managent would be the best for the "DIY" person, with no clue of engine mangaments
thanks

 

ghettodyne / turboedit your obd0

 

can anyone second that motion?
where can i get the info on that?(i went to ghettodyne.com but i couldn't find anything about the B20z!!!)
thanks

 

honestly i don't think you would be using the b20 ecu for your application. im guessing that you would wanna use a b series vtec ecu. whatever b series ecu that you decide to use for your application is what you should look for. if they dont support your ecu, then you may need to get an ecu that is supported.