ZC trans on a D16Z6 in an EF.. what axles?
 

I was under the impression that the dohc ZC trans was the same as any other us d-series trans, I was wrong. My axles from my EF don't fit at all :-/

What are my options here? I know I can use an integra passenger side axle but the drivers side? The d16z6 doesn't have the bolt holes for the half shaft, well it does but they're not drilled or tapped so using a half shaft is kinda out of the question.


So basically my question is, are there any axles I can use that will drop right in without having to change inner joints or making a half shaft work?

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

Since there arent any replies im going to take a wild guess and say, ZC axles??

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

zc halfshaft


zc axles

or 90-93 teg axles with inner hub thingy removed that how I ran mine



thread your block with the right thread pattern for halfshaft


halfshaft bolts are a special kind and the only kind used in a car dont try a normal bolt unless you want major headaches


the bolts are a taper style


good luck

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

Could you nab the axles and half shaft off of a 1g integra?

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

noppers


totaly different


you could rig the half shaft only 2 bolts will line up


the axles are totally wrong spline

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

the problem is I dont have the zc half shaft; It was left in denver when I moved back. I can get it but it'll be a while.

I may try to snag a set of da axles and take the inner joints off and put them on my EF axles; or at least the drivers side and use a passenger side DA axle.

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

simple rule you need that zc shaft no other way around it

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

did you not read what i typed.

i'll just take the inner joint off a passenger side da axle and put it on the long civic cv shaft.... make a totally custom jdm axle y0

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

Probably gonna piss oil all over the place until the transmission case is empty. IDK though. I would imagine that the oil seal is different on that side. I know it is on a B series transmission.

Re: ZC trans on a D16Z6 in an EF.. what axles?
 

WONT WORK...

you all are forgetting something VERY important.... there is no way to mount the ZC intermediate shaft that he doest have [and probably wont be able to find], there are no threaded holes in the back of a D16Z6 to bolt the shaft to... just ZC;s and D16A6's... D16A6 was also in a Wagovan, they had intermediate shafts, and i have a bet that would work for this application....