I just picked up a ZC intermediate shaft with two half shaft axles. The seal in the intermediate shaft is torn up. Where can I get a new seal (which USDM car matches)?

 

.....? thats a tough one dude, because I am pretty sure its going to have to be a D-series intermediate shaft, and No USDM l3 trannys have them. You are mainly looking at the 88-89 teg and possibly a B-series 90-93 teg one working.

Jeff

 

yeah go here to the hasport website..they have bout damn near any info u can think bout for the ZC and what not.

Just look at the 88-91 civic/crx and you will see the link that says " Axle Info "

http://www.hasport.com/Tech/Hasport%20Tech.htm

they show you how to build your zc axles from other axles but if you dont want to build them they have a link to a site in that axle info section to a site called " raxles " and they can make the axles for you....its not really that hard...if you got paitience to do an engine swap then u can build the axles easily....go luck....

 

I dont think it says anywhere in hasports site, what seal will replace that ZC intermediate shaft seal..

Jeff

 

Thanks dude. It didn't answer my question about the seal but it answered other questions I had about the axles. You were a great help.

 

got me stumped on the zc seal..but if i could have sworn that hasport had some info on it....maybe that was my mistake....good luck

 

The part number listed (91205-PL3-A01) on the Hasport web site is for a 35mm shaft, OIL SEAL (35X56X, it more likely fits a 88-91 Si axle. I need a seal for a 40mm shaft, OIL SEAL (40X53X, which fits the 90-93 1.8L Teg axle. I just can't find the right part number for the ZC intermediate shaft.