Is this worth it?
Hey, got the winter to do something to my engine. But im a scared little girl when it comes to internals.
Here is a quote i got from a local shop for my ls/vtec build. I know i can buy some of the stuff cheaper, but kinda wnat an opinion. I dont have garage space this winter in my new house, so i cant really work on it even if i knew what was up. Labor- 800 pistons w/ rings SRP- 489 Eagle rods- 315 head studs- 125 Cometic gasket ls/ vtec-100 main girdle w/ studs 250 oil pump gears and high pressure shim- 275 devcon w/ machine work- 650 bottom end gasket set- 89.00 springs- 275 bearings- 185 head work- 325 water pump- 85 greddy timing belt- 145 shop- 45 Tansmission Labor- 250 phantom grip LSD- 250 And allow 150 for miscelanious parts And 1000 for Hondata s300 + all day dyno tuning. |
Re: Is this worth it?
uh...yea go for it.
|
Re: Is this worth it?
This or just do a boosted K20 ???
|
Re: Is this worth it?
Some of you price's are wayyyyyyyyy out there, BTW it is not "phantom grip," more like phantom slip. They suck stay away from it. Also I did not see any boost parts :P. Building a motor is not that hard, if you can read and follow directions you will be fine.
|
Re: Is this worth it?
I guess i just dont have much room or experience with building motors. and i dont want to mess up a perfectly good engine.
Already got the boost parts. turbonetics .60 cold .63 hot real greddy type s BOV tial 38mm WG shody ramhorn mani ecu chiped for chrome. i just dont know a tuner. read tons about tuning, but again. no experience and i dont have anyone to learn from around here. Just want some honest feedback if i should do this or not. and if it is worth the money. ive been savin for ever and i plan on finishing some sort of swap with my tax check. |
Re: Is this worth it?
Why would you have an ECU chipped for Crome, but still have $1000 allocated for Hondata S300?
|
Re: Is this worth it?
skip the phanton slip and get an OBX
|
Re: Is this worth it?
Devcon with machine work... for almost the cost of a sleeved block.
|
Re: Is this worth it?
Walk away.
Half that ---- is stuff you don't need, you need to read and learn for the winter. |
Re: Is this worth it?
^^ Yea. Someone is trying to break one off in your ass. Do you homework and learn. There is plenty of info out there. Do you have a local machine shop instead of a "performance" shop around? My machinist builds motor...and I know the prices aren't anywhere near that.
|
All times are GMT -5. The time now is 11:02 AM. |
© 2024 MH Sub I, LLC dba Internet Brands