VTEC oil pressure switch wiring question
Guest
Posts: n/a
VTEC oil pressure switch wiring question
I am swapping out my '92 dx motor for a Z6. I read the vtec wiring faq and have everything prewired pretty much for the swap tomorrow. My only question is about the vtec oil pressure switch. It has 2 wire connections, and the connector that is attached (wires cut) to the Z6 engine has a blue and a green wire, I think. Does it matter which of these wires is connected to the ecu and which one is connected to ground, because it is only a switch?
Guest
Posts: n/a
Re: VTEC oil pressure switch wiring question
Originally Posted by hatchdx-si
No, it does not matter. But if you refer to your handy manual, there`s the way to do it "by the book".
CSAddict: Yea I would have ended up doing that as a last resort. I figured if I have the switch on there might as well use it right?
0.0 BAR
Joined: Mar 2004
Posts: 0
Re: VTEC oil pressure switch wiring question
Originally Posted by jagojon3
Originally Posted by hatchdx-si
No, it does not matter. But if you refer to your handy manual, there`s the way to do it "by the book".
CSAddict: Yea I would have ended up doing that as a last resort. I figured if I have the switch on there might as well use it right?
Thread
Thread Starter
Forum
Replies
Last Post
