tuner toys rods
im using tuner toys h beams with vitara pistons and im havng a little problem. the pin is juss a little larger then the hole on the rods. where the wrist pin connects the rods with the pistons. i was wondering if i could juss bore out the hole to make it fit. i wouldnt be taking a lot out. i could get it in there with juss a little force but that would take away the whole floating factor.
|
Re: tuner toys rods
ya just die grind it out :P
|
Re: tuner toys rods
Originally Posted by highroller54
ya just die grind it out :P
|
Re: tuner toys rods
Is it really bigger?
Did you measure it? Or did the pin just nog go in? If you didn't measure it and tried to slide it in..remember to put some assembly lube...at least some oil on the pin...it will never go in without any lubrication. |
Re: tuner toys rods
no i didnt measure it. i also didnt even think about lubbing it. if that worked though wouldnt that mean it is still to tight.
|
Re: tuner toys rods
hahah u didint use lube?
|
Re: tuner toys rods
Originally Posted by superd
no i didnt measure it. i also didnt even think about lubbing it. if that worked though wouldnt that mean it is still to tight.
|
Re: tuner toys rods
its supposed to be fairly tight...or else there would be a ton of play and it would destroy itself
|
Re: tuner toys rods
i talked to tuner toys today they said that they had to hone out the rods for vitara pistons too. so tomorrow im going to auto zone to to get the honing tool
|
Re: tuner toys rods
I had to hone mine out using Arais pistons, its pretty easy
|
All times are GMT -5. The time now is 01:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands