superd

im using tuner toys h beams with vitara pistons and im havng a little problem. the pin is juss a little larger then the hole on the rods. where the wrist pin connects the rods with the pistons. i was wondering if i could juss bore out the hole to make it fit. i wouldnt be taking a lot out. i could get it in there with juss a little force but that would take away the whole floating factor.

con

ya just die grind it out :P

Cray91

I would, I got a steady hand with that drill nukka.

Semnos

Is it really bigger?
Did you measure it?
Or did the pin just nog go in?
If you didn't measure it and tried to slide it in..remember to put some assembly lube...at least some oil on the pin...it will never go in without any lubrication.

superd

no i didnt measure it. i also didnt even think about lubbing it. if that worked though wouldnt that mean it is still to tight.

Ravage70

hahah u didint use lube?

Mindless

hahahaha

superd

i talked to tuner toys today they said that they had to hone out the rods for vitara pistons too. so tomorrow im going to auto zone to to get the honing tool

HMT-Admin

I had to hone mine out using Arais pistons, its pretty easy