HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Hybrid/Tech (https://www.homemadeturbo.com/hybrid-tech-8/)
-   -   trans teardown (https://www.homemadeturbo.com/hybrid-tech-8/trans-teardown-13109/)

90civicdxtobezx 12-15-2003 06:57 PM

trans teardown
 
how does one EXACTYLY tear one down. i didnt use my zc trans when i did my swap.i got drunk and thought i could crack it open. wrong. i got the 10 or so bolts around it out and that was it. i coulkd not seperate the case form the bell.there was no force involved.well my si trans is wearing out and i want to use my zc trans come this spring and swap a hf 5 in. any info. sites to please

turboboy 12-15-2003 08:34 PM

Re:trans teardown
 
there are detent balls you will need to remove ( a few on the side, you will see the bolts, and there are balls and springs behind them). also, on the end of the trans there is a big cap you need to unscrew, underneath it there is a clip you will need to ------ as you seperate the halves....i think i said everything but im not sure

OnYx 12-15-2003 08:41 PM

Re:trans teardown
 
go buy a helms manual.......... ::)

turboboy 12-15-2003 08:45 PM

Re:trans teardown
 
the chiltons i had didnt show jack ---- about the trans, just how to take it out i think

88b16civic 12-16-2003 09:29 AM

Re:trans teardown
 
If i can remember from when i pulled mine apart with onlya chiltons.

There is a "plug" that fits a 3/8" ratchet, undue this and there is a cercip inside on the main shaft, undue this. You also have to then crack it open as far as you can and stick your fingers in and remove the reverse mechanism. Then it should come apart.

There is a special way to get it back together, since you can stick your fingers in and put back in the reverse, but i forgot.

turboboy 12-16-2003 10:13 AM

Re:trans teardown
 
i had the case seperated with the reverse still on there

ProzacOverdose 12-16-2003 09:24 PM

Re:trans teardown
 
the haynes manual is pretty lame but in the 88-91 civic/crx ones, it actually shows the tranny break down. go get it or go sit @ the auto store and read it. anyway...you'll get that dam tranny done. oh yeah..by the way....the jdm zc trans WILL need a mid half shaft. and the axles will have to be integs. the sohc axles will NOT fit...they are a little smaller in diameter. but you can change the inner cups of the sohc axles to 90-91 integ cups to run the off beat, 1 short, 1 long axles. but i'd suggest using the half shaft and the equal length axles...its larger. just a thought.

OnYx 12-16-2003 09:39 PM

Re:trans teardown
 
helms = factory service manual.

90civicdxtobezx 12-17-2003 08:22 AM

Re:trans teardown
 
thanks for the info. im buyin a manual, this should be fun


All times are GMT -5. The time now is 05:33 AM.


© 2024 MH Sub I, LLC dba Internet Brands