Re: spun bearing... last how long?
 

Was a d16y7 in a 96 civic cx hatch.

Re: spun bearing... last how long?
 

either way if you drive it like that you have a greater chance of ruining the crank, rod, or even the block if its a main bearing.


I put a d16y5 oil pump in my y7, i dont know if the shitty 96+ d's have a weakness in the crank oil holes or the pump but the more expensive "high performance" oil pump i purchased turned out to have a y5 part number.

Re: spun bearing... last how long?
 

Any tapping at all = damaged crank.

Re: spun bearing... last how long?
 

ya i got the bitch to give me a ride to school and a buddy home
probably not going to start the car till like spring
other then disconnecting the battery you guys have any good storage ideas for the winter
its in a under ground parking lot

Re: spun bearing... last how long?
 

If its knocking BAD then the crank will be fucked. but if its knocking faintly you can throw in a new or even used bearing and itll last. I polished my crank and threw in a used bearing and the engine lasted me a while. I used the old rod. I did it cuz I wanted to see if it woudl last and I didnt feel like pulling the tranny to change the crank. It ran well but spun it again.

Re: spun bearing... last how long?
 

You get 7-10k cheesing in a bearing like that, unless the crank is really heat scarred.

Re: spun bearing... last how long?
 

even if i get 2k ill be happy
it will be enough to learn/get a new tune going

Re: spun bearing... last how long?
 

knock knock


throw the crank in the trash


Or dont listen waste your time and money

storage ideas um windows up. My old civic sat around for almost 18 months before I worked on it again. New motor. Fresh fluids. Old tank of gas



Rapped the rev limiter for a good 10 minutes
fix a leak stuff clogged raditor after rapping blowing off a hose spraying sparkles all of my mad jdm motor



New hose



went rapping again


threw a rod 2 weeks later

Re: spun bearing... last how long?
 

i have another engine im going to build
im going to check the crank first but the only thing that will cost me is time and oil

Re: spun bearing... last how long?
 

Yeah I found a crank kit for cheap so 250 bucks later im gonna get my ---- back up as well. I couldnt find a god damn D anything around ehre that had less than 70k miles on it.