SAFC question
11-19-2007, 07:00 PM
#1
1.5 BAR
Thread Starter
Join Date: May 2007
Posts: 749
SAFC question
Assume that the SAFC is wired up correctly, yet still acts like it has no power and won't turn on. What could cause this? Is there an internal component in these that frequently goes bad/fries. Have taken it apart, nothing is obviously burned on the circuitboard. Any ideas/suggestions?
11-19-2007, 10:32 PM
#4
1.5 BAR
Thread Starter
Join Date: May 2007
Posts: 749
Re: SAFC question
Originally Posted by jagojon3
Both power and both grounds hooked up?
Originally Posted by Joseph Davis
Old blue screen unit? The display/screen died like clockwork.
This is the unit. Display looks white to me, is this the type that tend to burn out? Neither the power light nor the button/**** light up either.
11-19-2007, 10:39 PM
#5
Guest
Posts: n/a
Re: SAFC question
Nope I believe he's talking about the old SAFC that has buttons, not your SAFC2 with the wheel.
I may be wrong about the 2 power wires, I haven't hooked one up in over a year. I do remember that I used the same ground for both grounds though with no problems. I used an ecu ground.
I may be wrong about the 2 power wires, I haven't hooked one up in over a year. I do remember that I used the same ground for both grounds though with no problems. I used an ecu ground.
11-19-2007, 10:44 PM
#6
1.5 BAR
Thread Starter
Join Date: May 2007
Posts: 749
Re: SAFC question
Ya, I'm starting to think that it might have gotten shorted out (It's 2nd hand, never saw it work). Say it did get shorted and something on the board is fried, Can I solder in a replacement diode/resistor/capacitor to fix it, or is the whole thing fucked?
