recalibrate a tps??
when i put the si motor into my hf the tps sensor broke. so used the one off the hf motor. ever since then the check engine light has been on. i've tried to re-adjust the tps by hand and it still throws the code for the tps?? any suggestions. thanks
|
Re:recalibrate a tps??
did u reset the ecu?
|
Re:recalibrate a tps??
i dissconnected the battery and another time dissconnected the ecu fuse. any other way?
|
Re:recalibrate a tps??
what did you set the TPS to?
|
Re:recalibrate a tps??
don't know i just slapped it on, ecu light came on been running like that for a year know. throws a tps code
|
Re:recalibrate a tps??
Set the position of the TPS so that it reads 0.66k ohms across the bottom two leads in the TPS, reset the ECU, and you should be good to go. If not, you may have a bad backup TPS.
|
Re:recalibrate a tps??
which 2 pins do you do jim? 5v in and the ecu wire?
I just set them to .5 at closed throttle |
Re:recalibrate a tps??
I set them based on resistance, not voltage. I measure the resistance in ohms across the bottom two pins (of the three in the TPS on Hondas). The resistance should be in the range of 0.66k ohms. This can be done on the bench, so no car or ECU is required to set it correctly.
But, I think you are correct Jeff, the manual states the voltage for the ecu wire, and how to check it on the car. |
Re:recalibrate a tps??
Originally Posted by dvs-1
when i put the si motor into my hf the tps sensor broke. so used the one off the hf motor. ever since then the check engine light has been on. i've tried to re-adjust the tps by hand and it still throws the code for the tps?? any suggestions. thanks
|
Re:recalibrate a tps??
idle ony sets around 1500-2000. i'm going to give this a try. thanks
|
All times are GMT -5. The time now is 08:40 PM. |
© 2024 MH Sub I, LLC dba Internet Brands