So i have the LCA's from a 2nd gen teg and the sway bar...sway bar not installed....however i dont see it being a bolt on mod. Not to the car chassis for that matter. They bolt on to the LCA's but the hinges that usually go on the frame need to be tapped. that and the big *** exhaust is in the way.

Im sure i could rig something up but i want to know if this has been done withou modifying anything. SI hatches come with them but then again the rear is not as long as the 4 door ...any advice opinions?

Julio

 

personally i going to do the same mod on my 4 door
i already got all the parts.. form what i can see all u got to do is take off the top mounting brackets for the da
and bolt them to ur frame.. how do u ask.... ez the mounting brackets blot right into place were ur tow hooks go.. just unblot those and blot in the mounting brackets.. and ur set

 

sweet..but my big *** summit exhaust is in the way!

ill have to figure that one out!

 

I would have to agree w/ you Julio this topic should be in the FAQ.

 

Thank You for that!

I know their are more than 2 of us who roll 4 doors...

 

I rock a 4dr but I'm not old skool like Julio!

 

yeah your not old school or new school but middle school!

 

Damn I can't even think of a comeback to that one since I'm so clusteredfucked with hearing the bad news about OBD. Billy Joel said it best "only the good die young" RIP Rusy.

 

I roll a 4 door...Well used to, she's in bad shape right now, but I hope to restore her to better than her former glory. Doesn't yours have a stock reas sway bar? I think mine does. And how about the bars from a 88-91 lude, they're mucho beefy.