Quick couple questions
I have a 91 dx dual point with no head on the engine. I'm getting a y8 head to put on the beast. Now I've done some reading and I'm a little confused-- The easiest way to do this would be to convert car to mpfi and convert the head to obdo and run the vtec off an rpm activated switch right? And I guess this runs ok right? What distributor do I use for this setup. The other way I was thinking was converting to obd1 via jumper harness and running an obd1 ecu, but I would still have to convert dpfi to mpfi first right? If I convert to obd1 then I would use a z6 distributor and ecu, and I would have an ecu that runs the vtec properly. The jumper is around $50 so i'm not that worried about the cost. What should I do? WWJD?
|
Re: Quick couple questions
Do a mpfi swap first make sure car runs then install OBD1 conversion as it will run the vtec better and you get better engine management options such as Crome.
|
Re: Quick couple questions
Originally Posted by 90dx
Do a mpfi swap first make sure car runs then install OBD1 conversion as it will run the vtec better and you get better engine management options such as Crome.
|
All times are GMT -5. The time now is 04:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands